INTRODUCING VIBROCUBE
I'm Scott Robbins, W4PA, the owner of Vibroplex. One of the things I've heard again and again from American hams is how we don't like our small, lightweight CW paddle sliding around on the operating table when in use. When I took over
Vibroplex in 2009 I vowed I was going to create a large paddle that would stay in place on the desk and accomodate my large hand comfortably. The result of many hours of conversation with the ham community is VIBROCUBE.

IT'S SIX POUNDS OF SOLID STEEL
The VIBROCUBE registers just under 6 pounds on the scale. The base is USA-forged cold rolled steel, upper components are zinc, steel and brass. The finger pieces are hard red acrylic. Instead of magnetic tensioning, we use the tried and
true spring loaded method which provides a greater range of possible tension settings than magnets allow.

IT'S BIG?
Not really! The base measures 1.5" H x 3.5" W x 3.5" D, the overall height of the key with rubber feet installed is 4.25". The large oversize acrylic finger pieces are 2.125" at their tallest point. See the illustration below of the red
acrylic finger piece used on VIBROCUBE versus the standard finger piece as used on the Vibroplex Iambic Standard paddle. Large paddles accomodate a large hand easily and take minimal hand movement to use.

IT'S TOUGH
This is not a fragile, delicate device. All parts except the finger pieces
and the two decorative top jewels are metal. The base, mainframe, and lever
bars are electrostatic powdercoated in a wrinkle black finish. It's difficult
to chip or scratch the paint. Adjustment components are chromed brass; the
contact points are coin-grade silver. Four non-skid rubber feet are affixed to
the bottom for extra non-movement stability.

IT'S MADE IN USA
It's not merely "assembled in USA" - parts and components used on VIBROPLEX
are American made and all assembly is done in our facility in Knoxville, TN. We
proudly affix the MADE IN USA label to each and every VIBROPLEX key built.

IT'S AFFORDABLE
There are 3 versions of the VIBROCUBE available. The Standard version uses
our standard pivoting trunion pins and screws and is available in black finish.