Ameritron's Remote Coax Switch lets you remotely switch up to eight HF antennas -- so you can replace 8 coax feedlines with a single coax. Eliminate a tangle of troublesome coax and have a simple and near installation -- with just a single
coax feedline!

The RCS-10 consists of two units -- the weatherproof switching box that mounts on your tower or mast and the control unit that's placed at your operating station.

Outdoor Unit Features
Inexpensive and simple wiring: selects up to eight antennas using one four
ú conductor telephone type control line
High Power Capability: The RCS-10 relay box will handle over 5 kW into
ú matched loads below 30 MHz
Long Relay Life: UL/CSA/VDE approved sealed relays with 16 ampere
ú switching current rating. Tested to withstand
ú 1200V.
Flexible Mounting: The RCS-10 hardware accepts mast sizes from 1
ú inch to 2 1/4 inches
Compact: Approximately 5¬"W x 6-7/8"D x 3"H and weighs
ú just 3 lbs.
Reliable Connectors: Teflon UHF-style SO-239 females, internal
ú barrier strip for control lines
Low Voltage: Requires 10-15 Volts at less than 300 mA.
Wide Frequency Range: Covers DC-100 MHz with low SWR, loss, and good
ú isolation
Highly Weather Resistant: Sealed relays, stainless hardware, and U-V
ú resistant cover
Control Box Features
Power Requirements: The RCS-10 operates from a 12 Vdc power source
ú (120 VAC Adapter included). Uses any 4 conductor
ú control line (not supplied)
Easy-To-Read Antenna Indicators: Eight wide-spaced LED's indicate the selected
ú antenna
Size: Wide Profile 6¬"W x 4-5/8"D x 3¬"H helps
ú prevent unwanted movement when turning selector
ú switch
Flexible Interface: Accepts and outputs one-of-eight control
ú signals, and outputs three-line BCD data