Building on the success of the AT-1000Pro, LDG

Electronics has refined and expanded its flagship 1KW tuner. The AT-1000ProII has an Auto mode that automatically starts a tuning cycle any time the SWR exceeds a limit you set. Also, there are provisions for two antennas; you can switch
between them any time you need. For each antenna, there are 2,000 memories that store tuning parameters for almost instantaneous tuner setting whenever you transmit on or near a frequency you've used before. Just key and it tunes! The AT-
1000ProII will operate at any power level between 5 and 1,000
watts peak RF input.

The AT-1000ProII has a large, easy to read bargraph with two selectable scale ranges (100 and 1,000 watts) as well as SWR meter. The AT-1000ProII will interface with many popular transceivers, enabling their TUNE button to control the AT-
1000ProII's operation. Dedicated control buttons allow you to fine-tune capacitance and inductance on those rare occasions when the AT-1000ProII can't find a perfect match by itself.

SPECIFICATIONS

Microprocessor controlled Switched L tuning network
Two position antenna switch with 2000 memories for each position.
Adjustable threshold for Auto mode
Continuous coverage 1.8 to 54 MHz
Power rating HF (1.8 to 30 MHz):
- 1000 Watts Single Side Band
- 750 Watts CW
- 500 Watts Digital (RTTY, Packet, etc)
6 meters: 250 Watts (any mode)
Capacitor / Inductor fine tune controls
Tuning time: 0.2 recall, 10 seconds average, 30 seconds max
Tuning impedance: 6 to 1000 Ohms (approximately 10:1 SWR)
Dual meter scale 100/1000 watts and SWR
Tuning power: 5 to 125 watts maximum
Relay protection software prevents tuning when RF power is high
Soft touch buttons
Optional External 4.5" analog, LED backlit Meter
Includes 6 foot power cable
Power requirements: 11 to 15 volts DC @ 1Amp (user supplies power source)
Enclosure sizes: 10W x 11D x 3H (in inches)
Weight: 5.0 pounds