FEATURES
Our ALL NEW, GREEN LED, PIC rotator controller is packed with new features including AUTO-CALIBRATE, AUTO SLOW DOWN as limits are approached, ONE STEP PROGRAMMING saving all changes by exiting the program mode. SOFTWARE UPDATES directly
from our "m2inc.com" website Also included is increased circuitry and reed switch protection. Of course computer control has also been improved. The new RC2800PXAZ now accepts fractional inputs like 138.7 degrees and the Auto-calibrate
command from a computer or remote site. What we did not change is front and back panel layout so it doesn't require re-learning the controls and the actual operation is almost identical to the old units. Everything is just a bit smoother
and easier. The new PIC microprocessor lends itself to easier custom programming for special rotator control functions. This custom program can be downloaded directly through the RS-232 port on your RC2800PXAZ from our site on the WEB. Of
course this new controller works with any of our older OR2800DC rotators. It can also be easily modified to work with MOST of our older AC (OR2800AC) units as well. By ordering an RC2800PXAZ controller this design can control a Prop Pitch
Rotator with all the same features. If you have a very custom rotator system using a large AC or DC motor of almost any voltage or phase (like 3 phase 240 AC) the RC2800PXAZ design can control your rotator system. This same controller also
controls our line of Elevation rotators (Positioners) like the MT-1000AEL, MT-3000AEL, MT-4000 and the largest, MT-5000. The Elevation controller can be linked to the AZ controller and both then can be controlled by computer through a
single RS-232 line. We also have a Dual controller(RC2800PRK) in one rack mount case to control an AZ-EL system. The new RC2800PXAZ controller can handle any gear ratio from 1000 to over 50,000:1.

Our OR2800PXAZ rotator is now supplied with a 60" PIGTAIL and a WATER TIGHT HOUSING for a terminal strip. This creates an easy access, trouble free control cable connection. Your control cable can have as few as 2 motor wires (see the "size
VS distance" information later in manual) and a small single shielded lead for the position feedback.